The short answer
The best sealant depends on where the leak is: a low-modulus, neutral-cure silicone suits most glazing joints, while a hybrid polymer sealant copes better with damp brick and flashing.
Always check the label says it is compatible with polycarbonate before using anything on plastic sheets.
If the roof leaks in several places, or the sheets themselves are cracked or brittle, sealant only buys time and a new roof is the real fix.
When a conservatory roof starts dripping, most of us reach for the nearest tube of sealant and a ladder. Sometimes that works. Often it does not, because the sealant went on in the wrong place, or the wrong sealant went on in the right place.
So before the question of which product, there is a more useful one. Where exactly is the water getting in?
Find the leak before you buy anything
Water on a conservatory floor rarely lands directly under the gap it came through. It runs along glazing bars, down the inside of the frame and across the ceiling of a lean-to before it drips.
Pick a dry day and work through these spots in turn.
- The joint with the house wall. The flashing, usually lead or a similar strip, tucked into the brickwork. On older red-brick houses, like many around West Park, the mortar joint it sits in can crumble with age.
- The glazing bars. Rubber gaskets and end caps shrink and crack, letting water creep under them.
- The ridge and any hips. Caps can lift or their seals fail.
- The box gutter, if you have one, running between the conservatory and the house. A blocked one overflows straight into the room.
- The sheets or glass units themselves. Cracks in polycarbonate, or failed seals on double glazing.
If you cannot see anything obvious, a hose run gently over one section at a time, with someone inside watching, will usually find it.
Is the water appearing on cold mornings rather than after rain? That may be condensation, not a leak at all, and no sealant will help.
Which sealant for which job
Once you know where the leak is, the choice becomes much simpler. Here is a general guide. Always follow the maker’s label on surface preparation and compatibility.
| Where the leak is | Type that usually suits | Watch out for |
|---|---|---|
| Joints along glazing bars and glass edges | Low-modulus, neutral-cure silicone | Some silicones can harm plastic sheets; check the label for polycarbonate |
| Flashing against brick or render | Hybrid polymer sealant, or flashing tape | Rake out loose mortar first, or the seal fails with it |
| Small cracks in polycarbonate | Clear sealant rated for polycarbonate | A cracked sheet usually needs replacing soon |
| Ridge and end caps | Neutral-cure silicone, or new caps and gaskets | Old gaskets under the cap may be the real problem |
| Box gutter joints | Gutter sealant or a hybrid polymer | Clear the gutter first; blockages cause many leaks |
Hybrid polymer sealants, sometimes sold as MS polymer, are popular because many of them grip damp surfaces and can be painted. Neutral-cure silicone stays flexible as the frame expands and shrinks with the weather. Whatever you choose, clean and dry the joint, take off the old sealant, and work on a mild, dry day.
One leak, traced
Say your conservatory drips at one corner after heavy rain, and only when the wind blows from the west. On a dry day you find the lead flashing has pulled away from the brick at that end and the mortar behind it has crumbled. Re-pointing that joint and sealing the flashing with a hybrid polymer or flashing tape will probably fix it. Smearing silicone along the glazing bar below would not, however much you used.
When sealant is not the answer
Sealant is a repair for a sound roof with one or two weak points. It is not a fix for a roof that is worn out.
You may find you are past the point of patching if the polycarbonate has gone yellow and brittle, if leaks keep moving from one spot to another, or if you have resealed the same joint more than once in a couple of years. At that stage, the money spent on sealant and ladders starts to add up for no lasting gain.
A replacement roof is a bigger outlay. Take a medium conservatory, about 3.5 by 3.5 metres: new polycarbonate sheets sit in our guide at £2,500 to £4,000, and a glass roof on the same room at £3,500 to £5,000. Both are national figures, not adjusted for Wolverhampton, and a guide rather than a quote. Try your own size and roof type in the price calculator.
Swapping like for like does not usually need planning permission. Moving to a solid roof is a bigger change and normally needs building regulations approval, which our regs page explains.
Before you climb the ladder
Never kneel or stand on conservatory roof sheets or glass. Neither is built to hold an adult, and going through one is a much worse day than any leak.
If the leak is somewhere you can only reach from the roof itself, that is a job for someone with the right access equipment. And if you are on your third attempt at the same joint, it may be time to look at the options on the Conservatory Roofs Wolverhampton homepage instead.
Where this comes from
Rules and figures above are drawn from the pages below, which open in a new tab.
